Precautions for using right angle reducer

Precautions for using right angle reducer:

1. Hammering is prohibited

When installing the output shaft of the right-angle reducer, do not directly hammer coupling components such as couplings, pulleys, and sprockets. Since the output shaft structure of the right-angle reducer cannot withstand axial hammering, the screws can be screwed into the screw holes at the shaft end and pressed into the coupling.

2. Be sure to install the ventilation cap (exhaust plug)

Before use, the blockage at the highest position should be replaced with an exhaust plug to ensure that the right-angle reducer can be exhausted during normal operation. If it is not replaced in time, the long running time of the reducer will cause the gas in the reducer to swell the oil seal, causing the reducer to leak oil.

Recommended reading

Stepper motor

Planetary reducer

Stepper motor

Forms and prevention of reducer gear tooth failure

The steps, methods and application process of stepper motor driver to realize drive control