Introduction to windings of angle reducer

We may not be very unfamiliar with the mechanical equipment of the angle reducer, but it is likely that the winding skills related to it are still a little vague and unclear. Then let me give you a brief introduction to the winding expertise of the angle reducer:

The angle reducer can be selected according to the rated current, which must be bi-imide, mono-imide and lack of double steel wires. Various specifications, such as silk, finished raw materials, can be formed in a circle on the spindle type of the coil inductor winding machine, which is generally very The linear part of the short coil of the tooth flank of the difficult reducer is 25 cm, and the linear part of the very large coil is 1.2 m. The relevant coil inductance can be a single flat winding, a single vertical winding, or of course a double flat exchange winding, or a double flat Swapping the vertical windings we can build methods based on specific requirements.

Adjustments within the round wheel can also be made around the round coil: the winding machine can be placed on the corner reducer speed and the turbocharger turbine reducer is welded, and then the winding machine can be promoted for 0 - 120 RPM reversibility suitable for rotation The braking system can even be counted on both sides, and the hard-toothed coils of various types of ordinary reducers around 1600 kW. In addition, a set of simple tensioning devices can control the tension of the coil inductor coil. General automobile repair manufacturers can choose the above products - if they meet different large, medium and small models and specifications, they can also choose non-special types of coil inductance mechanical equipment.

Recommended reading

CGF-042L2-16-P2

Stepper motor

Stepper motor

Stepper motor speed change measurement

What are the characteristics of closed-loop stepper motors?